Linxi Solar Photovoltaic Panel Installation

How to install a solar photovoltaic system?

The installer should conform to all the safety precautions listed in this guide when installing the module. Local codes should also be followed in such installations. Before installing a solar photovoltaic system, the installer should become familiar with the mechanical and electrical requirement for such a system.

How do I install a solar system?

Follow these guidelines: Research local building codes and permit requirements. Most solar installations require an electrical and/or building permit. Determine if your utility requires an interconnection agreement to connect your solar system to their grid. Contact them early in the process. Decide between a DIY or professional install.

What is the application level of LONGi Solar module?

The application level of LONGi Solar module is Class II, which can be used in systems operating at > 50 V DC or >240 W, where general contact access is anticipated; When the modules are for rooftop application, it is necessary to take the overall fire rating of the finished structure as well as operation and maintenance into account.

Can a LONGi Solar module junction box be mated together?

Make sure all connectors are fully locked. Only connectors as the compatible model from same vendor can be mated together. Any doubt, please consult LONGi customer service personnel. LONGi solar module junction box contains bypass diode which is in parallel connection with the cell string.

How to install PV modules in hot and humid environment?

PV modules install under hot and humid weather condition. PV modules installation site is under long-term humid environment such as water floating application. To reduce the risk of PID, on the modules DC connection site, it is recommended to connect the negative to ground.

How to maintain a solar PV system?

Observe the maintenance instructions for all components used in the system, such as support frames, charging regulators, inverters, batteries, etc. Removing the bypass diodes should be done only by a competent PV technician and after the module has been disconnected from the system.