Photovoltaic bracket clamp specifications and dimensions table

How far should a clamp be connected to a PV module?

Clamps should be connected to the module between 300 and 400 mm from the edge of the module. This distance is from the module edge to the middle of the clamp. *NOTE: Need two support rails below the PV module to make sure the Mechanical load. *NOTE: The above-described distance is from the module edge to the middle of the clamp.

What is a solar module clamp?

Module Clamps are Type 304 stainless steel for higher yield strength and durability. Pre-assembled module clamps feature no loose parts and a spacer that keeps free standing clamps in place for a quicker module installation. Patented. Note: Replace xxx with module depth from the Solar Module Specification Sheet.

What is a module clamp?

See Assembly Instructions. Module Clamps are Type 304 stainless steel for higher yield strength and durability. Pre-assembled module clamps feature no loose parts and a spacer that keeps free standing clamps in place for a quicker module installation.

Which Racking clamps should I use for Trina Solar racking?

For C structure steel type 1 racking, due to the amount of space inside the racking section, many choices are available including T-shape nuts. Please consult with a Trina Solar engineer before installing with the frameless clamps. Clamps should be connected to the module between 300 and 400 mm from the edge of the module.

What is the maximum voltage a photovoltaic module can run?

For roof use, the maximum system voltage must not exceed 600V according to National Electrical Code. Under normal conditions, a photovoltaic module is likely to experience conditions that produce more current and/or voltage than reported at standard test conditions.

What are the components of a solar stack pedestal system?

The system is a non-separately derived system. The following components have been evaluated for bonding as the fault current ground path: PV module, Mid Clamp, End Clamp, Pedestal and Ground Lugs. Solar Stack pedestals can be installed on BUR (Build Up Roong), Mineral surface (Modied Bitumen), EPDM, PVC, TPO, Hypalon and Concrete roofs.