National photovoltaic panel industry inspection standards

What are the standards for photovoltaics?

There are numerous national and international bodies that set standards for photovoltaics. There are standards for nearly every stage of the PV life cycle, including materials and processes used in the production of PV panels, testing methodologies, performance standards, and design and installation guidelines.

Why are international standards important in the photovoltaic industry?

ABSTRACT: International standards play an important role in the Photovoltaic industry. Since PV is such a global industry it is critical that PV products be measured and qualified the same way everywhere in the world. IEC TC82 has developed and published a number of module and component measurement and qualification standards.

What are the NFPA requirements for solar PV systems?

The electrical portion of solar PV systems shall be installed in accordance with NFPA 70. CS512.2 (IFC 1204.2) Access and pathways. Roof access, pathways, and spacing requirements shall be provided in accordance with Sections CS512.2.1 (IFC 1204.2.1) through CS512.3.3 (IFC 1204.3.3).

What conditions should a roof support a photovoltaic panel system?

Roof structures that support photovoltaic panel systems shall be designed to resist each of the following conditions: 1. Applicable uniform and concentrated roof loads with the photovoltaic panel system dead loads.

What are the requirements for ground-mounted photovoltaic panels?

Ground-mounted photovoltaic panel systems shall comply with Section CS512.1 (IFC 1204.1) and this section. Setback requirements shall not apply to groundmounted, free-standing photovoltaic arrays. A clear, brushfree area of 10 feet (3048 mm) shall be required for groundmounted photovoltaic arrays. CS512.5 (IFC 1204.5) Buildings with rapid shutdown.

Does NFPA 70 cover solar panels?

The installation of Photovoltaic Solar Systems is also addressed in NFPA 70. CS502.1 (IBC 1505.1) General. Roof assemblies shall be divided into the classes defined in this section. Class A, B and C roof assemblies and roof coverings required to be listed by this section shall be tested in accordance with ASTM E108 or UL 790.