Spherical camera solar panel bracket installation

How do I attach a solar panel to my camera?

1. Secure the solar panel's mounting bracket to the top of the camera. 2. Install the solar panel onto the solar panel's mounting bracket by turning it. 3. Connect the USB-C connector to the USB-C port of the solar panel. 4. Drill holes with a 15/64 inch (5.95 mm) drill bit with the included positioning card, then insert the anchors into the holes.

How do you mount a solar camera on a wall?

The camera can be mounted on a wall or on the ceiling. 1. Drill holes with a 15/64 inch (5.95 mm) drill bit with the provided positioning card, then insert the anchors into the holes. 2. Connect the solar panel to the camera using the provided USB-C extension cable. 3. Firmly secure the camera onto the mounting bracket.

Where should a solar panel be installed?

Choose an install location with the most direct sunlight. If you are in the Northern Hemisphere, direct your Solar Panel towards the south. If you are in the Southern Hemisphere, direct your Solar Panel towards the north. Make sure there is nothing blocking sunlight from your Solar Panel. Hardware included Tools needed

How do I install a solar panel?

Make sure there is nothing blocking sunlight from your Solar Panel. Hardware included: Tools needed: 2. Screw the bracket to the wall. If mounting to brick, concrete or stucco, use wall anchors and 6mm drill. 3. Slide the Solar Panel onto the bracket until it clicks into place. 4. Loosen the adjustment nut and adjust the positioning as required.

How do I connect my solar panel to spotlight CAM Pro?

Wrap any spare cable round the cable holder, and clip the cable into one of the cable stops. Connect your Solar Panel to your Spotlight Cam Pro, using the USB-C cable. Use the cable clips to secure the cable in place. Was this article helpful?

How do you attach a solar panel to a wall?

Screw the bracket to the wall. If mounting to brick, concrete or stucco, use wall anchors and 6mm drill. Slide the Solar Panel onto the bracket until it clicks into place. Loosen the adjustment nut and adjust the positioning as required. Tighten the adjustment nut when positioned.