Solar Engineering Pipe Bracket Installation Diagram

How do I connect a solar stack module to a pedestal?

Modules should be bonded to the Solar Stack pedestals with the manufacturer approved middle/end clamps. Grounding hardware (as a part of the module clamps) forms secure electrical bonds with both the module and the pedestal, resulting in many parallel grounding paths throughout the system.

How do I install a solar stack module?

Insert the middle clamps and tighten them. Insert the end clamps laterally in the pedestal. The end clamps are attached and then tightened at the height of the module frame. Modules should be installed to the Solar Stack pedestals with the manufacturer approved middle/end clamps.

Who should install a solar panel?

All electrical installation and procedures should be conducted by a licensed electrician or solar contractor. Routine maintenance of a module or panel shall not involve breaking or disturbing the bonding path of the system. All work must comply with national, state and local installation procedures, product and safety standards.

How should a solar module be mounted?

Modules mounting guidelines should be followed at all times. Ensure recommended rail spacing is consistent with the provided structure. It is the sole responsibility of the customer to ensure that a compatible module is used. Solar module width and/or length will determine the exact rail spacing.

What are the components of a solar stack pedestal system?

The system is a non-separately derived system. The following components have been evaluated for bonding as the fault current ground path: PV module, Mid Clamp, End Clamp, Pedestal and Ground Lugs. Solar Stack pedestals can be installed on BUR (Build Up Roong), Mineral surface (Modied Bitumen), EPDM, PVC, TPO, Hypalon and Concrete roofs.

How do I install a solar stack roof?

Surface Preparation. All roof surfaces must be free of any debris, dirt, grease, oil, and standing water before adhesive is applied. Follow adhesive manufacturers application instructions. Tile roofs: Tiles must be cut to t the proper size of the Solar stack pedestal (+- 1''). Clean the hole of any sawdust with appropriate tools and materials.