GoodWe Photovoltaic Inverter USB Instructions

How do I connect a goodwe inverter?

When connecting the inverter make sure to adjust the voltage and the frequency in compliance with the grid regulations and the specifications of the GOODWE. Add a breaker or fuse to the AC side. Please note that the specification should be more than 1.25 times of rated AC output current. The PE line of the inverter should be connected to earth.

Who can install a PV inverter?

Only qualified professionals or trained personnel are allowed to install, operate, maintain, and replace the equipment or parts. The inverter is a single-phase PV string grid-tied inverter, which converts the DC power generated by the PV module into AC power for loads or the grid.

Where can I download the software for a PV inverter?

The methods document of using the software can download from goodwe website or contact with after sales. Note: When sunlight is insufficient, the PV Inverter may continuously start up and shut down automatically due to insufficient power generated by the PV panels, which would not lead to inverter damage.

What is the rated power of a PV inverter?

The intended use of the inverter is as follows: 6000: the rated power is 6000W. The PV system is not suitable to connect equipment that relies on a stable power supply, such as medical equipment to sustain life. Ensure that no personal injury is occurred when the system is disconnected.

How to connect a PV inverter to a DC cable?

Make sure that the max short circuit current and the max input voltage per MPPT are within the permissible range. Make sure that the positive pole of the PV string connects to the PV+ of the inverter. And the negative pole of the PV string connects to the PV- of the inverter. Connect the DC cables using the delivered PV connectors.

How to set up a power switch on a PV inverter?

Tap Settings→Load Control to enter load control page and select the working mode. Working mode: Power Switch Mode, Time Mode and Backup Load Control Mode. Turn on or of the loads via PV Master app directly. Select Power Switch Mode and tap ON. Once the inverter receives ON command, the contactor will be connected and loads be powered on.